Customer Service
+1 888 812 6287


Couldn't load pickup availability
The Xantrex Freedom XC Pro 3000, MPN 818-3010, is a combined inverter/charger for RVs, boats and work vehicles with larger 12-volt battery banks. As an inverter, it delivers 3000 watts continuous at 40 °C of true sine wave AC, with a 6000-watt surge for up to 5 seconds to start air-conditioner compressors, refrigerators and other motor loads. Output is selectable at 120, 110 or 108 V AC, and 60 or 50 Hz. On shore or generator power, it charges the batteries at up to 150 A. The charger is power-factor corrected and configurable for lithium-ion batteries, and Xantrex states it can charge batteries from as low as 0 V. The store listing also notes battery equalization for flooded batteries and a Power Share function that reduces charge current to keep total AC input within your breaker setting.
When incoming AC power is present, the transfer relay passes it to connected loads and switches the unit into charge mode. Xantrex rates the relay at 50 A surge and 40 A continuous, with an AC pass-through range of 85–140 V AC. A built-in communications card supports RV-C, NMEA 2000 and J1939, and firmware and settings load through the USB port. Ignition control lets a 12 V DC signal switch the inverter on and off. The DC operating range is 10.1–18.0 V, with 304 A DC nominal current at full inverter load. Xantrex lists 91% peak efficiency and ≥84% at full load. The unit measures 15.4 × 10.8 × 4.9 inches without flanges and weighs 18.6 pounds. Xantrex lists ETL certification to CSA 107.1, UL 458 and the UL 458 Marine Supplement (with drip shield 808-1050), plus ABYC E-11, A-31 and A-32 compliance and FCC Part 15 Class B.
At full inverter load the XC Pro 3000 draws over 300 A DC, so battery capacity, DC cable size and fusing must be planned from the owner's guide. Confirm that your shore or generator supply can provide up to 25 A of AC input at full charge rate, and configure the charge profile for your battery chemistry. Configuration and monitoring use the optional Bluetooth remote panel (808-0817-02) or the wired remote panel (808-0817-01). For a plug-in GFCI outlet, choose the GFCI built-in model 818-3010-11 or add GFCI option 808-9817.
This listing ships one Freedom XC Pro 3000 inverter/charger. The shipping options and delivery estimate for your address appear at checkout. Our full terms are on the shipping policy page: https://marinerswarehouse.com/policies/shipping-policy
Before installation, confirm a 12-volt battery bank sized for over 300 A of inverter draw, and identify its chemistry so you can set the correct charge profile. Size DC cables and fusing from the owner's guide, set Power Share to match your shore breaker, and have a qualified installer connect the AC input and output terminals. Order a remote panel for on-board configuration and monitoring.
Review the 16 oz gel format, specifications and application directions.
Check fiberglass, gelcoat and finish suitability before use.
Ask about your surface and stain type before ordering.
Review shipping information and return conditions before purchase.
Installation & Compatibility Guides
The Freedom XC Pro 3000 inverts, charges and transfers AC for larger 12 V systems. Check these six points before you buy.
The 818-3010 is a 12-volt model, operating from 10.1 to 18.0 V DC.
Full inverter load draws 304 A DC. Size the battery bank, cables and fusing from the owner's guide.
Configure the charger for your battery chemistry. Lithium-ion is supported; equalize only flooded batteries that allow it.
At full charge rate the charger draws up to 25 A AC. Use Power Share to stay within your shore breaker.
Keep pass-through loads within the relay's 40 A continuous rating.
Add a wired or Bluetooth remote, choose 818-3010-11 or kit 808-9817 for a GFCI outlet, and fit drip shield 808-1050 for the marine listing.
Both Freedom XC Pro models combine a true sine wave inverter, a lithium-capable charger, an AC transfer relay and built-in RV-C, NMEA 2000 and J1939 communications. The XC Pro 3000 steps up to 3000 W of inverter output, a charger of up to 150 A and a 40 A continuous transfer relay. It suits larger battery banks and loads such as rooftop air conditioning within its rating. The XC Pro 2000 provides 2000 W, a 100 A charger and a 24 A continuous relay.
If you only need inverting with transfer and already have a dedicated charger, compare the Xantrex Freedom X 3000 inverter. Choose by whether you need charging, then by inverter output, charger current and transfer capacity.
Use these collections to compare inverter/chargers, inverters and other RV equipment. A collection link is for browsing and does not confirm compatibility.
Compare combined inverter/chargers and standalone chargers by charge current, inverter output and battery support.
Browse standalone inverters if you already have a separate charger.
Return to the parent collection to find another product family for your RV, truck or boat project.
Need Help?
Need help comparing Xantrex Freedom XC Pro 3000 Inverter/Charger, SKU 84512, MPN 818-3010? Share your battery chemistry and capacity, your shore breaker size, the loads you plan to run (including any air conditioner), and whether you use RV-C or NMEA 2000. These details help us understand your selection question before you order.
Trusted by 50,000+ boat owners across the USA
Our team has years of experience in marine parts.
We respond quickly to get you the help you need.
We make sure you get the right part the first time.
Access to 50,000+ marine parts & accessories.
Thanks for subscribing!
This email has been registered!